1575 mhz saw filter 2.4 mhz bandwidth part number: SF1575BA02505S idt ? saw products ? 324 clark street, worcester, ma 01606, usa ? ph 1-508-852-5400 ? fax 1-508-852-8456 www.idt.com dsSF1575BA02505S rev - 6-dec-2006 page 1 of 3 description ? miniature 1575 mhz saw bandpass filter us ed as rf filter in gps applications. ? 3 x 3 mm ceramic lcc package. ? rohs compliant. typical performance
1575 mhz saw filter 2.4 mhz bandwidth part number: SF1575BA02505S idt ? saw products ? 324 clark street, worcester, ma 01606, usa ? ph 1-508-852-5400 ? fax 1-508-852-8456 www.idt.com dsSF1575BA02505S rev - 6-dec-2006 page 2 of 3 specification parameter min typ max units center frequency f c - 1575.42 - mhz bandwidth 2.4 - mhz insertion loss 1 - 1.3 1.8 db passband amplitude ripple 1 - 0.7 1.0 db stopband rejection 2 , 0 to 1450 mhz 40 44 - db stopband rejection 2 , 1450 to 1500 mhz 30 35 - db stopband rejection 2 , 1625 to 1640 mhz 30 35 - db stopband rejection 2 , 1640 to 2000 mhz 45 48 - db stopband rejection 2 , 2000 to 3000 mhz 30 35 - db terminating impedance 50 ? // 0nf notes: 1. within passband: 1574.22 to 1576.62 mhz 2. rejection relative to insertion loss maximum ratings parameter min max units storage temperature range -40 +85 oc operating temperature range -40 +85 oc input power level - +10 dbm d.c. voltage between each terminal - 10 v matching circuit notes: 1. matching components are not required. input 50 ? source sin g le ended output 50 ? load sin g le ended
1575 mhz saw filter 2.4 mhz bandwidth part number: SF1575BA02505S idt ? saw products ? 324 clark street, worcester, ma 01606, usa ? ph 1-508-852-5400 ? fax 1-508-852-8456 www.idt.com dsSF1575BA02505S rev - 6-dec-2006 page 3 of 3 package outline suggested footprint iso 9001 registered all specifications are believed to be accurate and reliable. ho wever, mnc reserves the right to make changes without notice. ? 2006 all rights reserved. package material: body: al 2 o 3 ceramic lid: kovar, ni plated terminations: au plating 1 m min, over a 1.3-8.9 m ni plating units: mm tolerances are typically 0.15 mm except where indicated. pad configuration: input: 2 output: 5 ground: 1,3,4,6
|